Everything below concerns certificate of analysis. We keep the language plain, cite what the science says, and separate well-supported claims from open questions.
Updated 2025-12-01. Numbers and descriptions here follow the published literature rather than marketing material.
Common synonyms in catalogs include pentadecapeptide BPC 157, BPC157, and the full sequence name. A CAS registry number in the 137525-51-0 range is frequently listed, though the assignment should be verified against the supplier certificate of analysis. The name itself is not a pharmacopoeial designation, and there is no standardized international nonproprietary name. Distinguishing genuine material from related fragments generally requires mass spectrometry, since several truncated sequences share similar chromatographic behavior.
BPC-157 is a synthetic pentadecapeptide whose sequence is commonly given as Gly-Glu-Pro-Pro-Pro-Gly-Lys-Pro-Ala-Asp-Asp-Ala-Gly-Leu-Val. It is described in the literature as a fragment of a larger protein found in human gastric juice, referred to as body protection compound. The peptide was first characterized in the early 1990s by a research group in Zagreb, Croatia. Its molecular formula is C62H98N16O22 and its monoisotopic mass is approximately 1419 daltons.
Supplied material is typically a lyophilized white to off-white powder. The peptide is freely soluble in water and in common aqueous buffers, which allows it to be handled as a stock solution. Because the sequence contains no cysteine, disulfide cross-linking is not a route of degradation. The absence of aromatic residues means ultraviolet absorbance at 280 nm is minimal, so quantification usually relies on peptide bond absorbance near 214 nm or on amino acid analysis.
Within the research literature, the peptide is discussed through several provisional mechanisms, including cytoprotection, modulation of growth factor signaling, and interaction with the nitric oxide system. None of these mechanisms is fully characterized, and no single pathway is universally accepted. Review articles typically note the gap between consistent animal findings and sparse human evidence. The compound is classified as a research chemical rather than an approved pharmaceutical, which shapes how studies are designed, funded, and reported.
BPC-157 is a synthetic pentadecapeptide with the sequence GEPPPGKPADDAGLV, corresponding to a partial fragment of a larger protein detected in human gastric juice. The name derives from the parent protein designation BPC, an abbreviation of body protection compound, with 157 acting as a fraction or batch identifier used by the original investigators. Its molecular weight is approximately 1419 daltons, and the chain contains no unusual residues or disulfide bridges. In the literature it is described as a short, water-soluble fragment rather than a complete natural protein.
Most early work on this peptide originated in the 1990s from a research group in Zagreb, Croatia, relying on animal models and cell cultures. Reported observations included effects on gastrointestinal lesion healing, tendon fibroblast migration, and blood vessel formation under controlled laboratory conditions. These findings come predominantly from rodent studies and in vitro assays rather than from human trials. Controlled human data remain limited, and the degree to which animal results translate to human physiology is an open question rather than a settled fact.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white lyophilized powder | Assessed by visual inspection under ordinary laboratory lighting |
| Molecular mass | Approximately 1419 Da | Monoisotopic mass for the fifteen-residue sequence |
| Solubility class | Freely soluble in water | Stock solutions commonly prepared in water or aqueous buffer |
| Typical storage temperature | -20 °C or below, desiccated | Lyophilized powder; repeated freeze-thaw cycles are usually avoided |
| Common analytical method | Reversed-phase HPLC with UV detection | Frequently paired with mass spectrometry to confirm identity |
Purity is ordinarily reported as a percentage from reverse-phase high-performance liquid chromatography, where the area of the main peak is compared with the total peak area. Identity is confirmed by mass spectrometry, since the measured mass can be checked against the value calculated from the sequence. Some certificates also include amino acid analysis or sequence confirmation by tandem mass spectrometry. A single purity number does not describe the profile of related impurities, so the underlying chromatogram and spectrum usually carry more information than the headline figure.
Material of this kind is sold for laboratory research, and labels typically state that it is not intended for human or veterinary use. In many countries it is not an approved medicine, and sports antidoping rules place it among prohibited non-approved substances. Buyers commonly review a certificate of analysis, an independent test report, and the declared storage conditions. Batch-to-batch variation in purity and in counterion content is possible, and how much that variation affects experimental outcomes remains an open question.
Lyophilized peptide is normally kept at minus twenty degrees Celsius or colder, away from light and moisture. Powder held under those conditions is widely treated as stable for long periods, although published stability studies for this exact sequence are sparse and often come from suppliers rather than independent laboratories. Once dissolved, solutions are generally handled cold and used within a short window, because peptide bonds can hydrolyze over time. Repeated freeze-thaw cycles are usually avoided to limit losses, and exact shelf-life figures depend on the buffer and the concentration involved.
Quality assessment rests on two separate questions: whether the chain is the intended one, and how much of the sample is that chain. Reverse-phase high-performance liquid chromatography with ultraviolet detection is the standard purity measurement, while mass spectrometry confirms identity through the observed molecular mass. Amino acid analysis and sequence verification provide further checks. A reported purity percentage describes the proportion of the sample represented by the main peak, not the amount of peptide by mass, since counter-ions and water make up part of any lyophilized lot.
In its usual supplied form, the peptide is a white to off-white lyophilized powder that dissolves readily in water and in aqueous buffers. Powder keeps far longer than solution, so material is normally shipped and stored dry, then dissolved only when needed. Once in solution, the chain is subject to hydrolysis and the liquid supports microbial growth, and practical guidance generally treats the dissolved form as short-lived. Containers should stay sealed and desiccated, because the powder takes up moisture from air.
Human data are far more limited than animal data. A small number of clinical reports exist, generally with few participants and without the randomization or blinding expected in later-phase trials. No large, independently replicated human trial has appeared in the indexed peer-reviewed literature. Statements about effects in people therefore rest on extrapolation from animal work rather than on direct evidence, and the strength of that extrapolation remains an open question rather than a settled matter.
Proposed mechanisms include interaction with the nitric oxide system, modulation of growth factor signaling, and effects on blood vessel formation. None of these has been established as the primary mode of action, and some proposed pathways rest on indirect measurements. Whether the reported effects depend on a specific receptor has not been determined. Stability in gastric acid, unusual for a peptide of this size, is also reported in animal work, but the reason for it is not firmly established.
Lyophilized peptide powder is generally stored at minus twenty degrees Celsius or lower and kept away from light and moisture. Under these conditions degradation is slow, and sealed vials remain stable for extended periods. Once dissolved, the material is less stable, particularly in aqueous buffers near neutral pH, where hydrolysis and oxidation proceed faster. Solutions are usually kept cold and used within days to weeks. Repeated freeze-thaw cycles are avoided because they encourage aggregation.
Identity and purity are established using reversed-phase high-performance liquid chromatography, which separates the peptide from related impurities and yields a percentage purity. Mass spectrometry, typically with electrospray ionization, confirms the molecular mass against the expected value. Amino acid analysis or peptide mapping provides additional sequence confirmation. These methods are complementary, since chromatography measures how much material is present while mass spectrometry verifies what that material is. A certificate of analysis normally reports both.
Hydrogen halides and their solutions: hydrofluoric acid (HF), hydrochloric acid (HCl), hydrobromic acid (HBr), hydroiodic acid (HI) Halogen oxoacids: hypochlorous acid (HClO), chlorous acid (HClO2), chloric acid (HClO3), perchloric acid (HClO4), and corresponding analogs for bromine and iodine Hypofluorous acid (HFO), the only known oxoacid for fluorine. Sulfuric acid (H2SO4) Fluorosulfuric acid (HSO3F) Nitric acid (HNO3) Phosphoric acid (H3PO4) Fluoroantimonic acid (HSbF6) Fluoroboric acid (HBF4) Hexafluorophosphoric acid (HPF6) Chromic acid (H2CrO4) Boric acid (H3BO3) A sulfonic acid has the general formula RS(=O)2–OH, where R is an organic radical. Methanesulfonic acid (or mesylic acid, CH3SO3H) Ethanesulfonic acid (or esylic acid, CH3CH2SO3H) Benzenesulfonic acid (or besylic acid, C6H5SO3H) p-Toluenesulfonic acid (or tosylic acid, CH3C6H4SO3H) Trifluoromethanesulfonic acid (or triflic acid, CF3SO3H) Polystyrene sulfonic acid (sulfonated polystyrene, [CH2CH(C6H4)SO3H]n)
The Bergmann degradation is intended for and has been used as a method for peptide sequencing. It was also proposed for use in cleaving the 3,4-bond of the penicillin nucleus. The compound 2,2-dimethyl-6-phthalimido-3-penamyl isocyanate was arrived at through various means, including the Curtius rearrangement, and it was envisioned that it could undergo the Bergmann degradation to form the desired aldehyde as well as the urea by-product. Though the Bergmann degradation was indeed possible, it was discovered that simple dilute acid hydrolysis would suffice in forming the desired product.
The protein is 82.3 kDa and has a 40 amino acid long LEM domain located at its amino-terminal region. In its carboxyl end it has a RNA recognition motif (RRM). The LEM domain is also common to two other integral proteins of the INM: lamina-associated polypeptide 2 (LAP2) and emerin. The LEM segment enables LEMD3 to attach to the barrier-to-autointegration factor (BAF), and therefore, indirectly interact with the chromatin. LEMD3 also has several implications in regulating the cytokine family such as the transforming growth factor beta (TGF-β) and bone morphogenic protein (BMPs). The RRM domain in its carboxylic region attaches to the SMAD (protein) proteins, which is involved in mediating TGF-β cellular signalling. Consequently, LEMD3 indirectly regulates downstream genes. LEMD3 seems to play an important role in regulating the expression of several fundamental genes. LEMD3 has been associated with laminopathies as well as osteopoikilosis. Mutations in the LEMD3 gene have been linked to several genetic diseases such as osteopoikilosis, melorheostosis and Buschke–Ollendorff syndrome.
Annals of Clinical Biochemistry is a bimonthly peer-reviewed scientific journal covering all aspects of clinical biochemistry. The editor-in-chief is Michael J Murphy (University of Dundee). It was established 1960 and is published by SAGE Publications on behalf of The Association for Clinical Biochemistry and Laboratory Medicine. The journal is abstracted and indexed in: According to the Journal Citation Reports, its 2012 impact factor is 1.922, ranking it 12th out of 31 journals in the category "Medical Laboratory Technology". Official website
The predecessor of modern countercurrent chromatography theory and practice was countercurrent distribution (CCD). The theory of CCD was described in the 1930s by Randall and Longtin. Archer Martin and Richard Laurence Millington Synge developed the methodology further during the 1940s. Finally, Lyman C. Craig introduced the Craig countercurrent distribution apparatus in 1944 which made CCD practical for laboratory work. CCD was used to separate a wide variety of useful compounds for several decades.
Sources: en.wikipedia.org
Chinese hamster ovary (CHO) cells are a family of immortalized cell lines derived from epithelial cells of the ovary of the Chinese hamster, often used in biological and medical research and commercially in the production of recombinant therapeutic proteins. They have found wide use in studies of genetics, toxicity screening, nutrition and gene expression, and particularly since the 1980s to express recombinant proteins. CHO cells are the most commonly used mammalian hosts for industrial production of recombinant protein therapeutics.
14-3-3 proteins are a family of conserved regulatory molecules that are expressed in all eukaryotic cells. 14-3-3 proteins have the ability to bind a multitude of functionally diverse signaling proteins, including kinases, phosphatases, and transmembrane receptors. More than 200 signaling proteins have been reported as 14-3-3 ligands. Elevated amounts of 14-3-3 protein in cerebrospinal fluid are usually a sign of rapid neurodegeneration; a common indicator of Creutzfeldt–Jakob disease.
Tranexamic acid can be used in skincare products as a cosmetic active to reduce the appearance of inflammation and hyperpigmentation. Tranexamic acid is a zwitterion amino acid, and has a low permeability coefficient in the stratum corneum. Tranexamic acid can be combined with penetration enhancers and microneedling to overcome this limitation. Cosmetic uses may also employ lipophilic derivatives of tranexamic acid (ester prodrugs like Cetyl tranexamate mesylate) that are not zwitterionic and thus have improved skin permeability. Allergic to tranexamic acid History of seizures History of venous or arterial thromboembolism or active thromboembolic disease Severe kidney impairment due to accumulation of the medication, dose adjustment is required in mild or moderate kidney impairment
Leukolike vectors are a type of nanoparticles made of nanoporous silicon encapsulated by extracted native leukocyte membranes. These particles were among the first artificial white blood cells to be studied as a proof of concept of using cellular membranes to prolong circulation of nanoparticles throughout the blood. Studies have shown that leukolike vectors have a specific advantage in chemotherapy drug delivery to cancer. This is because leukolike vectors specifically have the potential to bind to tumor endothelium.
Sources: en.wikipedia.org
It is a synthetic peptide built from fifteen amino acids, with a mass of roughly 1419 daltons. The sequence is reported to match a fragment of a protein present in human gastric juice. It is not a naturally circulating hormone.
It is normally supplied as a lyophilized powder in a sealed vial. The powder dissolves readily in water, and stock solutions are typically prepared shortly before use. Cold storage is standard laboratory practice.
The letters are generally read as shorthand for body protection compound. That label comes from the original research context rather than from formal nomenclature. No standardized nonproprietary name exists for the peptide.
The sequence corresponds to a fragment of a protein found in human gastric juice, so related sequences are natural. The isolated fifteen-amino-acid peptide supplied for research is produced synthetically. Whether the free fragment circulates naturally in humans has not been settled.